
Used Taikan T-500 S Vertical Drilling and Tapping Center
Taikan · T-500S
2026 · Mitsubishi M80 · China
Built in 2026 and in near-new condition, this JiRFINE LM 2218 gantry machining center has seen very little service since installation. It is equipped with the FANUC 0i-MF Plus CNC control system and a BT50 spindle running up to 6000 rpm. The worktable measures 2000 x 1500 mm and carries loads up to 6 t. X/Y/Z travels are 2200 / 1800 / 800 mm, with a gantry width of 1850 mm and gantry height of 1050 mm. The 15/18.5 kW spindle motor drives the BT50 spindle. All three axes run on THK heavy-duty roller linear guideways (X 55 / Y 55 / Z 65). Tooling changes are handled by an Okada 24-station disc-type tool magazine, and the machine is equipped with a nitrogen balance cylinder, an oil cooler and a dual chip conveyor combining screw-type and chain-type discharge. The machine remains installed in a factory in Ningbo, China, and is available for inspection.
FANUC 0i-MF Plus CNC control system; BT50 spindle, 6000 rpm; oil cooler; nitrogen balance cylinder; screw-type + chain-type dual chip conveyor; Okada 24-station disc-type tool magazine; THK heavy-duty roller linear guideways on all three axes (X 55 / Y 55 / Z 65)
| Worktable size | 2000 x 1500 mm |
|---|---|
| X/Y/Z travel | 2200 / 1800 / 800 mm |
| Table load capacity | 6 t |
| Gantry width | 1850 mm |
| Gantry height | 1050 mm |
| Spindle motor power | 15 / 18.5 kW |
| Spindle speed | 6000 rpm |
| Spindle taper | BT50 |
| Tool magazine capacity | 24 stations |
| Tool magazine type | Disc-type (Okada) |
| Guideway type | THK heavy-duty roller linear guideway, X 55 / Y 55 / Z 65 |
| Chip conveyor | Screw-type + chain-type dual chip conveyor |
| Year of manufacture | 2026 |
| Brand | JiRFINE |
| Control system | FANUC 0i-MF Plus |
Related inventory

Taikan · T-500S
2026 · Mitsubishi M80 · China

QUASER · MV184D
Year on request · Siemens · China

Taikan · T-V1260
Year on request · FANUC · China